发信人: hw (好玩), 信区: ANSI
标 题: Re: 提问...
发信站: 日月光华 (2007年01月28日16:25:30 星期天), 站内信件
不是结束字符的问题，呵呵，与行数计算，显示位置有关
【 在 Syracuse (MssCmm·雪) 的大作中提到: 】
: 那我肯定少加了什么结束字符之类的自己缪发现
: 再bow~~
: 【 在 hw (好玩) 的大作中提到: 】
: : 如果是光标移动，那要看情况，只在同一行内移动一般没问题(要求显示字符控制在80个
: : 以内)，用[A和[B跨行的，如果控制得好，问题应该也不大。
--
BBS客户端探测程序(仅支持cterm、fterm、sterm、qterm以及WinXP telnet)
您当前所使用的是：
ctermIII fterm sterm Win telnet qterm <SFC(100,222,255) T(0,-10,"CTERMIII")>
※ 来源:·日月光华 bbs.fudan.edu.cn·[FROM: 222.70.10.189]
※ 修改:·hw 於 01月29日15:45:20 修改本文·[FROM: 222.70.14.163]
Sender: hw fun, message area: ANSI
Title: Re: Question...
Sending site: Sun and Moon Guanghua January 28, 2007 16:25:30 Sunday, site mail
It’s not a problem with the ending character. Haha, it’s related to the calculation of the number of lines and the display position.
Mentioned in Syracuse MssCmm Snow's masterpiece:
: Then I must have added some ending characters or something, and I discovered it myself.
: Bow again
: Mentioned in hw’s fun masterpiece:
: : If it is a cursor movement, it depends on the situation. It is generally no problem if it only moves within the same line. It is required to control the display characters to 80.
: : Within, use [A and [B to cross lines). If the control is good, the problem should not be big.
BBS client detection program only supports cterm fterm sterm qterm and WinXP telnet
You are currently using
ctermIII fterm sterm Win telnet qterm <SFC 100,222,255 T 0, 10,"CTERMIII" >
Source: Sun and Moon Guanghua bbs.fudan.edu.cn [FROM: 222.70.10.189]
Modification: hw modified this article at 15:45:20 on January 29 [FROM: 222.70.14.163]
