Sender: hw fun, message area: ANSI Title: Re: [Reprint] Two Goblins Sending site: Sun and Moon Guanghua Monday, August 06, 2007 22:47:37, site mail Don’t write too much. Well, the parameter of the H control code refers to the coordinates of the current screen when this line of code is interpreted, the upper left corner. It is *[1;1H and the lower right corner is *[24;80H. In fact, it usually only goes to line 23. Line 24 is the status bar. When writing the code, there are no 3 lines of article header, 4 lines of letterhead and an additional blank line. These will be there after the article is published. Okay, don’t forget these lines for the positioning code for the first screen. Side-by-side "fairy" does not necessarily need to be done with H. Of course it is possible to use H, but the coordinates must be written correctly. Mentioned in hw's fun masterpiece: : Poor, I’m wondering if I should write something specifically : Mentioned in BOneFiveER onlyone's masterpiece: : It seems that Guanghua’s system is very different from Weiming’s. : I added three codes : *[5;70H,*[6;62H,*[7;68H : It should be understandable : There is no problem when viewing under esc c : When I finally posted it, it should be the reason why *[H lost control : I don’t understand. I don’t understand. BBS client detection program only supports cterm fterm sterm qterm and WinXP telnet You are currently using ctermIII fterm sterm Win telnet qterm <SFC 100,222,255 T 0, 10,"CTERMIII" > Source: Sun and Moon Guanghua bbs.fudan.edu.cn [FROM: 222.70.15.29] Modification: hw modified this article at 23:16:32 on August 06 [FROM: 10.8.225.9]