Sender: allenwu Unregistered user. Ignore me. I’m annoyed. Get lost. Message area: ANSI Title: 9. Hide IP Sending station: Sun and Moon Guanghua December 14, 2003 00:46:14 Sunday, in-site mail People often ask this question. In fact, if you want others not to see the real IP, then shuttle or use a proxy. Otherwise, you can usually see the real IP. Explore friends at night and look around for IP addresses in the status. You can hide them by setting personal parameters in the toolbox. Adding *[23;1H to the IP at the end of the qmd may make the source line appear on line 24 and be removed from the bottom. The information bar is covered, but it depends on the situation. It may not always be successful. For articles that cover more than one screen, it is basically certain. It will fail. In the past, there was a rumor that *[46 used incomplete control symbols to "hide" the source line. Put It is better not to use this outside the visible area of ​​​​the screen. Moreover, it is not guaranteed to be successful. On the contrary, it may cause certain problems. Some unpredictable results. In Guanghua, there is a way to change the IP to anything by exploiting a "loophole" in the code. The text you want. This method is not universal. People who want to know more can go to Guanghua’s essence area to have a look. Although it can also It causes a little inconvenience, but in Guanghua this may be the most perfect way to modify the IP at the end of the article. If the system does not disable the special ANSI escape sequence in smd, you can use the cursor to specify the IP address in smd. Bit *[H to overwrite the original content In some BBS such as Guanghua, you will indeed find that some people’s IPs have been changed to some specific words. No matter what You can't get the real IP by checking in any way. That's a special setting. For example, the webmaster can hide the IP, but ordinary users can't. Arrived Source: Sun and Moon Guanghua bbs.fudan.edu.cn [FROM: 10.85.24.241]